Ignition Repair & Replacement in Broad Ripple, IN

Yes, and it is one of the busiest overnight markets in the service area. The stretch of College Avenue and Broad Ripple Avenue through the village generates steady car lockout calls between midnight and 3am on weekends. Typical arrival is 15 to 25 minutes.

Yes, and it is standard work here. Rekeying takes roughly 10 minutes per lock, so a typical student rental is done in under an hour. July and August are the busiest turnover months around Butler, so book ahead if you can.

Not always without modification. Bungalows through Meridian-Kessler, Warfleigh and Butler-Tarkington often have non-standard backsets and older mortise bodies that off-the-shelf hardware does not match. The technician measures the backset and bore before recommending hardware, and in many cases repairing the original lock is both cheaper and better suited to the door.

Give a cross street rather than just a block number. Street parking in the village is dense and addresses are hard to read at night. The nearest intersection plus the vehicle colour and make gets a technician to you noticeably faster.

The most common causes are a locked steering column, the shifter not fully seated in park, a worn key, or worn wafers inside the cylinder. Try firmly rocking the steering wheel left and right while turning the key, and confirm the shifter is fully in park. If neither frees it, the cylinder or key is worn.

Yes. Ignition work is done at the vehicle wherever it is parked — driveway, workplace lot or roadside. The column trim is removed on site, the cylinder is rebuilt or replaced, and the trim is refitted. Towing to a dealer is not required.

Usually not. On most vehicles the replacement cylinder can be pinned to match your existing key, so one key still runs the doors and the ignition. On a few platforms the cylinder is not re-pinnable and comes with its own key, in which case you are told before the work is authorised.

Call to describe the ignition problem and your vehicle. A cylinder rebuild, replacement cylinder and immobilizer programming involve different work and parts. Inspection may be needed to determine the right repair. The technician explains the proposed work and confirms the total before starting.

Yes. The broken section is extracted with specialised tools, then the cylinder is inspected for damage. Often the cylinder is fine and only a replacement key is needed. If the break was caused by an already-worn cylinder forcing the key, the cylinder is repaired at the same time.